29
6
INSTALLATION INSTRUCTIONS
Caution:
The sterilizer must be placed on a rigid and leveled surface. The counter must
be able to hold the load of the device and loaded material as follows:
Model
1730
2340
2540
3140
3850
3870
lb
75
106
117
172
245
278
load on
Counter
kg
34
48
53
78
111
126
Note:
Make sure while placing the autoclave, to leave space around the machine, to
give the technician access to service the machine.
6.1
Electrical
The electrical connection should comply with the device's power
requirement. It must also comply with local installation and safety rules
and regulations. The voltage supplied to the device must comply with the
label
5%.
In order to avoid any injury by electrical hazard, it is mandatory for the
customer to have installed an earth leakage relay (GFI outlet or circuit
breaker) in the electrical circuit to which the autoclave is connected. This
relay disconnects all the poles of the electrical power line in case of
accidental contact with the autoclave’s metal enclosure, by the operator
or another person, leading to a dangerous leakage current.
Note: Keep the back and the right side of the autoclave approximately 1”
(25mm) away from the wall to allow for ventilation.
Connect the power cord to the socket on the rear side of the autoclave;
plug it into the supply outlet. The autoclave must be connected to a
properly grounded outlet.
6.1.1
Setup for new units 2340, 2540, 3140, 3850 & 3870
Your new Tuttnauer Autoclave was set at the factory and requires a
minimal of setup.
Make sure the counter is level and sturdy.
Make sure all the feet are on the autoclave and none have been
lost.
Position the autoclave on the counter.
Fill the reservoir with distilled water (see sec 6.5).
The unit is ready to operate.
Summary of Contents for 1730E
Page 2: ......
Page 16: ...14 REAR VIEW EA EKA only Cut Out Thermostat Reset button...
Page 41: ...39 MAINTENANCE INSTRUCTIONS...