INSTRUCTIONS
OLYMPUS METAL PLATE INSTALLATION
1
3. Place the duffel bag on the top rack and route the straps through the D-rings on the 4 corners of the bag.
4. Buckle the straps together and tighten so the bag is firmly compressed against the top rack.
CAUTION
- SECURE ALL STRAPS.
- INSPECT LUGGAGE BEFORE AND DURING RIDING TO ENSURE THAT
CONTENT SHIFTS HAVE NOT CAUSED STRAPS TO LOOSEN.
- MAKE SURE STRAPS/BAGS ARE NOT IN CONTACT WITH ANYTHING HOT OR SHARP.
- WARRANTY IS NOT VALID FOR MELTED/DAMAGED BAGS, STRAPS,
OR PERSONAL PROPERTY DUE TO IMPROPER INSTALLATION.
Refer to www.rockymountainatvmc.com for replacement parts
Thank you for choosing Tusk High Quality products for your adventure needs. Everyone at Tusk is dedicated
to delivering the highest quality products possible to enhance your adventure riding.
Please carefully read/follow these instructions to ensure the best experience with your new purchase.
Universal Metal Plate
Hardware included
1. Metal Plate Qty: 2
5. 10mm bolt Qty: 4
2. “U” Brackets Qty: 8
6. 30mm Bolt Qty: 8
3. “L” Brackets Qty: 4
7. 24mm Washer Qty: 16
4. 16mm Bolt Qty: 8
8. 13mm Lock Nut Qty: 8
Tools needed
5mm Allen/Hex Key
13mm Wrench
1. Loosly mount four (4) “U” Brackets using the 16mm Bolts and two (2) “L” Brackets with
the 10mm Bolts to the plate.
2. Place the Universal plate on the pannier rack of your motorcycle. Depending on your pannier
rack system you may need to move the brackets to different slots.
3.Tighten down the four (4) “U” Bolts and two (2) “L” Bolts so the plate is fixed in that location. Ensure
the plate is still able to be removed and re-mounted easily with minimal free play.
4. Repeat the process on the other side, remove both plates and route the 1.5” strap through the plates.
**Be mindful of which plate you had on which side and what bag you are mounting to it. We recommend
installing the bag so the side pocket with the drawstring is towards the front of the motorcycle.**
5. Mount the bag to the plate by feeding a 30mm bolt and 24mm washer through the inside of the bag towards the
outside where you will place another washer and then loosely screw on a 13mm lock nut. Repeat the process
until all 4 corners of the bag are mounted to the metal plate, make sure no loose straps are between the bag
and the metal plate. Tighten the four (4) 13mm bolts on each bag.
Caution
- ** Check the bolts periodically and tighten any that may have come loose.
