GB
21
How to Mount Single and Twin Tanks to BC0501
(1) Remove the top back pad velcro strap from the BC harness D-ring exposing the
back plate wing nuts. (Fig. 68A)
(2) Remove both wing nuts,
freeing the dual tank bands
or single tank adapter. When
removing the single tank
adapter, the webbing from
the top cam strap will also
have to be removed.
(Fig. 68B)
(3) To attach dual tanks, configure the tank bands on the scuba cylinder so that the
center bolts are positioned approximately 207mm apart. Slide the bolts through the
BC bladder, harness and back plate. Slide the rubber and stainless steel washers
onto each bolt. Tighten wing nuts until tanks are secure.
(4) To attach the single tank adapter, feed the bolts (supplied) through the aluminum
tank plate, bladder, harness and back plate. Slide the rubber and stainless steel
washers onto each bolt. Secure the single tank adapter by tightening the wing
nuts. Feed the upper cam strap trough the bladder, harness and back plate. When
threading tank belt, refer to Fig. 14-22.
BCJ ATTACHMENT
(Fig. 69)
(1) Put the BCJ on your back and tighten the shoulder
belts by pulling the D-shaped rings (Fig. 69) on the
front edge of the shoulder belts, tightening them
enough to fit comfortably to your body. Stoop forward a
little, as if you were carrying a child on your back, so as
to lessen the burden of the tank on your back.
(Fig. 70)
(2) Tighten the cummerbund securely and fasten with the
Hook and Loop fastener (Fig. 70).
Make sure that the hook is overlapping exactly on top
of the Loop on the cummerbund.
* If there is not exact overlap, you must adjust the
length of the waist belt (see page15).
(Fig. 68A)
(Fig. 68B)
