21.08.
油门曲线
Throttle Curve
功能说明:
用来调节飞机油门的操作曲线，使
摇杆
动作和
油门
的响应相协调，为了补偿油门不线性问题；
此设置可以调节
油门曲线
的
11
个点（
L
，
2~10
，
H
）从
0%
调整到
100%
，水平的点线显示油门
摇杆
的即时位置，垂直的点
线显示此功能应用后
油门输出
的即时位置；当飞机结构没有
引擎（
如
滑翔机 )
时将没有
油门曲线
功能, 主菜单中没有此功能图
标。此功能可分别在
5
个
状态
下设定。
激活开启按钮后点触需设置的点进行设置，滑动转轮调节相应数值。
如图
21
.
10
所示：点触
开启
按钮激活了
油门曲线
功能，调节2点数值至20.0%，3点数值至36.5%，4点51.5%，5点64.0%，
6点74.1%，7点80.0%，8点85.5%，9点90.0%，10点95.0%，在这种设定下
油门摇杆
在中位以下（即L，2~6点）油门输出
相对
油门摇杆
在中位以上（即6~10，H点）加油较快,在设置曲线时，可以选择
3/5/7/9/11
点
V
性和
/
型曲线。
28
21.09.
油门延迟
Throttle Delay
功能说明：
用来降低油门输出的响应速度，比如模仿涡轮发动机的慢速响应等. 可设定
0~10s
，默认
为
0s
。当飞机结构没有
引擎
（如
滑翔机
）时将没有
油门延迟
功能，主菜单中没有此功能图标。
滑动转轮调节延迟时间，红色条线图表示油门
摇杆
的位置，绿色条线图表示通道的位置。
如图
21
.
11
所示：调节延迟时间为
5s
，此时油门
摇杆
从最低端打到最高端，因为有5秒延迟，
当前位置为1秒时的油门通道即时位置，显示为20。
(
Pic 21.10)
(
Pic 21.11)
Function Details:
This function enable the user to adjusts the
operation curve of the aircraft throttle and make it coordinate the
stick
movement
and
throttle
output to compensate the non-linear problems of the throttle.
The 11 points (L, 2~10, H) of
throttle curve
can be adjusted from 0% to 100%. The horizontal dotted line displays in real time
the throttle
stick
position. The vertical dotted line displays in real time the position of the
throttle output
after the
throttle curve
function has been applied. If the airplane and helicopter does not have an
engine
, this icon will not be displayed. This function can
be set in five
conditions
.
Select the desired point to set and move the wheel to modify the corresponding value afteractivating this function.
For this example 21.10: The
throttle curve
function is activated. Point 2 is set 20%, point 3 30%, point 4 40% and point 5
50%,point6 74.1,point 7 80%,point 8 85.5%,point 9 90.0% and point 10 95.0
%
. In this situation, when theposition of the
throttle
below the neutral, that is (L,2~6), the acceleration of the
throttle needle
outputis faster than its position above the neutral ( that is
6-10, H point),V-shaped curve and “/ ” shaped curve. The two curves can be set though 3 points, 5 points, 7 points, 9 points or 11
points.
Function Details :
Throttle delay
is used to reduce the response speed of throttle output and imitate turbine
engine
in airbrake, which can be set from 0s to 10s. If the airplane does not have an
engine
, such as a
glider
,
this icon will not be displayed.
Move the wheel to set the throttle delay time.The red bar represents throttle
stick
position and the
green bar represents channelposition.
As shown in the picture21.11: The delay time is 5 seconds. There will be 5 seconds
delay when moving throttle
stick
from bottom side to top side. Due to 5 seconds delay, the throttle is
in the position when it is one second and it displays 20%
Http://www.turnigy.com
