Turnigy
®
V-Bar 600
Flybarless System. Firmware V3.01
Preface
The Turnigy® V-Bar 600 is an extremely high quality precise controller and stabilizer for the swash plate and tail rotor of a
model helicopter flight control system. It has super-stabilization and super-response to control input. This makes for incredible
stability and agility. The programmability allows for performance settings from smooth scale to sport or hard 3D flying.
Flybarless also means longer flight times and a tremendous reduction in parts and aerodynamic drag. You no longer need to use
a separate external tail gyro, resulting in reduced weight, with a large cost savings. The Turnigy® V-Bar 600 offers 4 switchable
flight modes.
Technical details:
●MEMS Gyro Sensors in three axes
●Digital signal processor
●Operating voltage: 4-10 Volts, current < 80mA
●Temperature range: -10°C to +50°C
●Size: 33x34x18 mm
●Weight: 15 g
●Servo compatibility: 1520uS/333Hz, 1520uS/250Hz, 1520uS/167Hz, 960uS/333Hz (tail only) and 760uS/333Hz Digital
servos. Also, standard 1520uS/71Hz Analog servos.
●Supplied: Foam and double-side adhesive tape and Stainless steel plate.
Installation
:
Only use the thick double sided adhesive pads when installing the Turnigy® V-Bar 600 unit on an electric helicopter. If
installing on to a nitro or turbine helicopter, you may want to use the two double sided adhesive pads on the bottom plus a
stainless plate on the top of these, then a thin double sided adhesive pad on the top layer, for better vibration isolation.
