Ⅵ
Using the ESC
·
Calibrate the throttle range of transmitter at the first time to use the controller
(Recommend)
- Correctly connect the ESC with brushless motor, plug the receiver lead of ESC into receiver ( usually into
Channel 3);
- Put the throttle to the highest position, turn on the transmitter;
- Power on the receiver, ESC and motor. There are 3 beeps emitted from the motor, which indicates all
electronics are correctly power on for the setting.
- Then there are 4 long beeps emitted from the motor
♪
♪
♪
♪
.
- Waiting one second, there will be two beeps emitted from the motor
- Calibration of throttle is completed.
·
Program the ESC’ s settings or use the default setting (by Turnigy Program Card/ on PC/ by throttle stick)
Recommend:
Please always clearly know current parameters of ESC before use, and program it according to
your configuration. Please take the following form as reference to program the ESC ( Default setting is displayed
in blue. Throttle range in gray cannot be programmed but be auto changed after calibrating the throttle travel of
transmitter.) Seeing the appendix about the detail programmable features of Turnigy ESC-100A.
♪
♪
NOTE: 1).
Turnigy ESC-100A has no built-in BEC, so a separate receiver pack or UBEC is needed to supply
power for receiver and servos.
2).
If you have succeeded in calibrating the throttle range of transmitter, the throttle range will be
displayed in
‘Programming Set’ window
when you connect the controller to PC. The factory preset throttle
range is 640 uS.
LVC
Auto
5.0V
6.0V
(2 Lipo)
7.2V
8.4V
9.0V
(3 Lipo)
12.0V
(4 Lipo)
15.0V
(5 Lipo)
18.0V
(6 Lipo)
21.0V
(7 Lipo)
24.0V
(8 Lipo)
27.0V
(9 Lipo)
30.0V
(10 Lipo)
33.0V
(11 Lipo)
36.0V
(12 Lipo)
Current
Limiting
Sensitivity
Standard
Insensitivity
Disabled
Brake Type
No brake
Soft brake
Hard brake
Timing
Advance
Auto
Low
Middle
High
Cutoff Type
Hard cutoff
Soft cutoff
Startup Type
Soft start
Standard
Fast start
Governor
Mode
Auto
Governor
Low
Governor
High
PWM Rate
Low
Middle
High
Throttle
Range
640 uS
TURNIGY ESC-100A MANUALS
3 page / 14 pages
NOTE:
You also can program the ESC-100A through Turnigy Program Card, but a separate receiver pack
or UBEC (voltage must
be 5V-
6V
) is needed to connect to ‘Reserve for OPTO’. Please read the manuals of
‘Turnigy Program Card’ for more detail instructions.
- Move the throttle to the lowest position after each one beep of the four long beeps.
