2.11
<1>
Now it’s time for the stepper motors, these are labeled X, Y, Z, E0 for the given axis and
extruder. Note the color wire position when plugging in the 4 motors (
picture 2.11d
).
Picture 2.11d
Picture 2.11e
Picture 2.11f
Picture 2.11g
We are going to move to the terminal blocks start by turning the screws on blocks (
picture
2.11e
) D10, D9, D8 counterclockwise to open up the wire terminal. This allows us to insert
a wire and then by turning the screw clockwise it closes the terminal securing the wire
(
picture 2.11f
).
We are starting at block D10, which is the extruder heater. The two thick red wires need to
have the insulation carefully removed / stripped exposing the wires, remove approximately
7mm of insulation (
picture 2.11g
).
Now install one wire at a time. Insert the first wire into the first D10 slot and turn the screw
we just loosened clockwise till you feel the wire start to compress. Now turn the screw
½
a turn more. Do not over tighten the terminal blocks. Give the wire a tug and make sure
it feel secure and no stray wires are exposed (
picture 2.11h
).
Picture 2.11h
44
Summary of Contents for PRM0282
Page 1: ...User Guide 3D Printer 1...
Page 60: ...PRM0282...
