2.4
<1>
We need to tidy up the wiring a bit before we move on. There are cutouts in the panels
that allow zip tie to pass through and secure the wiring. Loosely install zip ties in these
slots so we can start roughing the wires through the loops.
These zip tie slots
will be used
Start by routing the
Y-axis stepper motor wires
(through the loop),
and the
“Y-max” sensor wires
down the
back right corner
cutout
(
picture 2.4a
).
Next route the
Z-axis stepper motor wires
and
“Z-max” sensor
wires
(through the loop), together with the wires down from the back
right corner and through another loop (
picture 2.4b
).
Next route the
“Y-min sensor wire
, together with all the wires from
point 1
and
point 2
mentioned above through the loop near the
front. Leave the loops loose as we will have more wires to pass
through later (
picture 2.4c
).
Back stepper motor wires
through the loop
Panel Cutout
Picture 2.4a
Picture 2.4b
1.
2.
3.
Z-axis stepper
motor & “Z-max”
sensor wires
“Z-min”
sensor &
wires from
above
“Y-max”
sensor
wires
Picture 2.4a
Picture 2.4b
“Y-max”
sensor
“Y-min”
sensor
“Z-min”
sensor
“Z-max”
sensor
Picture 2.4c
“Y-min” sensor
wires
Picture 2.4c
Routing the wires
22
Summary of Contents for PRM0282
Page 1: ...User Guide 3D Printer 1...
Page 60: ...PRM0282...
