Turnigy PRM0282, User Manual

Page: 23 / 60

2.5
<1>
X axis gantry
We need to install the Y axis rods onto the X axis gantry and
then install the XY gantry to the rear and side panels
Unscrew at one end
x 2
Gantry rail (Y axis rod)
x2 x1
2.0mm hex
driver
Remove the protective plastic from the side rods, then remove the rod adapter washer and rod
support, by losing the set screw (see below diagram).
Loosen this set screw on adapter
Now carefully slide the rod through the two support bearings on the X axis gantry (see below
diagram and picture). The direction and side is not important as both sides are the same
2.5
<2>
Once the rod is through both bearings, reinstall
the rod support washer and rod adapter
(note the flat spot on the end of the rod. This
lines up with the set screw on the rod adapter
while tightening)
Flat spot on the rod
Rod adapter
Rod adapter
Box-A
Find the following accessories from:
23