5. Lithium polymer balance charge program
connection diagram
-
9
-
TURNIGY 4X100W
INPUT cables. These cables are appropriate for attaching directly to most high-quality
AC-DC power supply units, such as Hobbyking 540W power supply (Part No.17755 200-
240V; Part No.17754 100-120V). Also included are large Terminal Clips with matching
4mm female bullet connectors, for attaching directly to 12V car batteries. It is critically
important that you use either a fully charged 13.8V car battery or a high quality AC-DC
power supply in the range of 12V to18V DC output, with minimum current rating of 30A to
insure reliable performance.
comes with male 4mm Bullet connectors attached to the power
CONNECTING THE CHARGER
4mm Bullet Connectors plugging
to Hobbyking power supply directly
(Part No.17754 100-120V)
(Part No.17755 200-240V)
CONNECTING THE BATTERY
Important !!! Before connecting a battery it is absolutely essential to check one last time
that you have set the parameters correctly. If the settings are incorrect, the battery may
be damaged, and could even burst into flames or explode. To avoid short-circuits
between the banana plugs, always connect the charge leads to the charger first, and only
then to the battery. Reverse the sequence when disconnecting the pack.
The balance wire attached to the battery must
be connected to the charger with the black wire
aligned with the negative marking. Take care to
maintain correct polarity!
This diagram shows the correct way to connect
your battery to the TURNIGY 4X100W while
charging in the balance charge program mode
only.
BALANCE SOCKET
WARNING:
Failure to connect as shown in this diagram will damage this charger.
To avoid short circuit between the charge lead always connect the charge cable to the
charger first, then connect the battery. Reverse the sequence when disconnecting.
