Turnigy 4x100W, Operating Manual

Page: 20 / 26

10. Program set up
It will be operated with the default value of the essential user settings when it is
connected to a DC 11~18V batttery for the first time.The screen displays the following
information in sequence and the user can change the value of parameter on each screen.
When you are willing to alter the parameter value in the program, press Start/Enter key to
make it blink then change the value with INC or DEC key. The value will be stored by
pressing Start/Enter key once.
PROGRAM SELECT
SYSTEM SET
User set up starting screen.
Rest Time
CHG
＞ DCHG 10Min
The battery is on the cyclic process of charge and discharge can
often become warm after charge or discharge period. The
program can insert a time delay to occur after each charge and
discharge process to allow the battery adequate time to cool
down before being subjected to the next process. The value
ranges from 1 to 60 minutes.
SAFETY TIME
ON 120Min
When you start a charge process, the integral safety timer
automatically starts running at the same time. This is
programmed to prevent overcharge the battery if it proves to be
faulty, or if the termination circuit cannot detect the battery full.
The value for the safety timer should be generous enough to
allow a full charge of the battery.
Safe timer Calculation
When charging NiCd or NiMH batteries, divide the capacity by
current, then divide the result by 11.9, set this number as the
value for safety timer setting. If the charger stopped at this
threshold, about 140% of the capacity will have been fed into the
battery.
Capacity
Current
Safety Time
2000mAh 2.0A
(2000/2.0=1000)/11.9=84 minutes
3300mAh 3.0A
(3300/3.0=1100)/11.9=92 minutes
1000mAh 1.2A (1000/1.2=833)/11.9=70 minutes
For example:
INC
DEC INC
DEC INC
DEC INC
DEC INC
Capacity Cut-Off
ON 5000mAH
This program sets the maximum charge capacity that will be
supplied to the battery during charge. If the deltapack voltage is
not detected nor the safety timer expired by any reason, this
feature will automatically stop the process at the selected
capacity value.
DEC INC DEC INC
DEC INC
-19-