™
17
A
1
2
3
4
TIGHTENING SEQUENCE
(TORQUE TO 23 ft-lbs)
C
B
C
B
D
E
Detail A
DISCARD SHIMS
3/16"
TO
1/4"
SEE NOTE IN STEP 7
FIGURE 11
SV85370-06
V-Belt Replacement (See Figure 11)
Use the following steps for V-belt replacement:
Step 1.
Disconnect the clutch cable at the clutch control
handle. Do not change the cable adjuster setting.
Step 2.
Remove the top guard.
Step 3.
Locate the shaft coupling
[A
] and disassemble.
Before disassembly, note the location of the
identifying punch mark
[B]
on the top half of the
coupling and the matching “X” marks
[C]
on the
upper and lower halves.
Step 4.
Remove the square key
[D]
from the shafts.
Step 5.
Remove and install the old and new V-Belt thru
the space between the shafts
[E]
.
Step 6.
Reinstall the key
[D]
.
Step 7.
Reinstall shaft connector
[A]
. Punch mark
[B]
must be towards the large pulley, the “X” marks
must both be on the same side of the connector.
The edge of the connector block should be 3/16” to
1/4” inch (4.8 mm to 6.3 mm) away from the edge
of the differential housing.
Note: If installing a new
connector, discard shims between the connector
halves.
Step 8.
Tighten bolts evenly in an “X” pattern (See
Detail A
For bolt tightening sequence). Torque to 23
Ft-Lbs. (276 In-Lbs or 31.1 NM).
Step 9.
Replace the top guard.
Step 10.
Reinstall the clutch cable to the clutch control
handle.
Step 11.
Test and readjust the clutch cable as needed.
SERVICE
