turck uprox BI10U-M18 Series, Operating Instructions Manual, Page: 14 / 32

14
Hans Turck GmbH & Co. KG | T +49 208 4952-0 | F +49 208 4952-264 | more@turck.com | www.turck.com
Product description
Switching hysteresis
NOTE
The switching hysteresis setting is only available for the “One switch point” function.
The switching distance hysteresis can be set to the 2 stages “Standard” and “small”.
NOTICE
“Small” hysteresis selected
Uncontrolled changing between the switching states
➤ ➤
Set the switching distance and target in the application so that a setting to “small”
hysteresis is possible.
Switch-on delay
NOTE
The switch-on delay can only be set for the “One switch point” function.
If the switch-on delay T
on
is activated, the switching pulse is generated after the actual sensor
actuation. The switch-on delay can be set between 0…60000 ms.
Abb. 7: Switch-on delay
The set output configuration is not changed. Switching pulses that are shorter than the set
switch-on delay are not transferred to the controller.
Switch-off delay
NOTE
The switch-off delay can only be set for the “One switch point” function.
If the switch-off delay T
off
is activated, the generation of the switch signal pulse is delayed by
the set time after sensor actuation.
Abb. 8: Switch-off delay
The set output configuration is not changed. Interruptions in switch pulses that are shorter
than the set switch-off delay are ignored at the output and are transferred with a switching
signal to the controller.