28
4.2.4 QuickConnect consideration
When QC is enabled, the device sets ETH1 an ETH2 ports as follows:
Fixed speed at 100Mb
Forced duplex at Full-duplex
ETH1 port set as MDI (straight-through wiring)
ETH2 port set as MDIX (cross-over wiring)
Auto-Negotiate and Auto-MDX are disabled
The TBEN-LH-16DIP QuickConnect operational time:
Ready-for-connection time = 100msec (time measured from the device power-up to the first
ARP)
NOTE
The incoming Ethernet cable is always connected to ETH1 port.
Use ETH2 port to daisy-chain to next node.
Verify setup using web server:
Figure 4.17
– Network settings while QC
