Turbosol T20X, Use And Maintenance Manual

Page: 32 / 84

3
SAFETY AND PREVENTION
32/84
561400 - IS16/09 - EN
Do not use or charge the battery if the electrolyte level is below the minimum notch. Add distilled water until
the level is between minimum and maximum.
Only check the charge status with voltmeter or densimeter.
The battery may emit potentially explosive gases. Do not use naked flames or smoke near it.
The battery electrolyte is toxic and corrosive. Do not inhale the gases. Wear adequate accident-prevention
clothing when before handling the electrolyte.
DANGERS ARISING FROM HYDRAULIC SYSTEM MAINTENANCE
The risks associated with the hydraulic system are:
- burn;
- injection;
- cutting;
- impact and crushing;
- perforation;
- dangers arising from handling lubricant fluids.
The hydraulic diagram must be understood before working on the machine.
Maintenance interventions requiring the disassembly of components must take place with the machine off
and cold.
Do not start the machine even if only one pipe is disconnected. Disconnect the battery cut-out switch before
working on the hydraulic system.
Repairs and extraordinary maintenance must be performed by authorised maintenance technicians.
Pressurised fluid jets can penetrate the skin and cause damage. Before disconnecting any pipe, make sure
there is no residual pressure inside (the circuit pressure gauge must be at zero bar). Wear adequate
accident-prevention clothing (gloves, goggles).
Replace damaged pipes, gaskets, O-rings or fittings.
DANGERS ARISING FROM PNEUMATIC SYSTEM MAINTENANCE
The risks associated with the pneumatic system are:
- burn;
- cutting;
- impact and crushing;
- dangers arising from handling lubricant fluids.
The pneumatic diagram must be understood before working on the machine.
Maintenance interventions requiring the disassembly of components must take place with the machine off
and cold.
Do not start the machine even if only one pipe is disconnected. Disconnect the battery cut-out switch before
working on the pneumatic system.