Appendix 1 - Reversing the Oven Door
28
Oven Door - Adjustment
Door Position Adjustment (Vertical Alignment):
1. To adjust the door vertical alignment, open oven door.
2. Loosen the screws securing
the top door hinge plate to
the oven.
3. Adjust oven door vertical
alignment position and
tighten the 2 cap screws.
4. Check door operation.
Repeat steps 2 and 3 as
necessary to ensure that
door closes and latches
evenly and is aligned in the
door frame.
Door Seal Adjustment:
1. With the oven door closed and
latched shut, loosen the upper hinge
pin.
2. Lightly push the top of the door in
the hinge area and tighten the
upper hinge pin.
3.
Repeat the adjustment for
the lower hinge
bracket.
Door Latch Adjustment:
1. Open
the
oven door to
reveal the locking dog.
2. Pull back the neoprene seal
to reveal the lock nut.
3. Slacken the lock nut.
4. Adjust the locking dog to
the required position.
5. Slam the door shut and
ensure that the door is not
a loose fit when closed and
that pressure is maintained against the door seal.
6. Continue to adjust the locking dog until the door shuts
correctly.
7. Tighten up the lock nut and re-position the neoprene seal over
the lock nut.
NOTE: Ensure that the Locking
Dog is aligned with the
hook facing downwards.
Microswitch Adjustment:
1. Open oven door.
2. Remove the control panel
and bend the microswitch
arm to adjust microswitch
operation.
3. Open and close the oven
door and check the
microswitch operates
correctly.
NOTE:
The microswitch should operate when door handle is
approximately
1
/
2
engaged (45°).
4. Repeat Steps 2 and 3 as required, then refit the control panel.
Lock Nut
Neoprene Seal
Locking Dog -
Hook Down.
Cap Screws
Tighten up
Top Pivot
Pin Nut
Gently Press
against door
Ensure that the gap at
the top and bottom of
the door are equal.
Microswitch Lever
Microswitch
