![turbofan E358D6-**-453 series Installation And Operation Manual Download Page 14](http://html1.mh-extra.com/html/turbofan/e358d6-453-series/e358d6-453-series_installation-and-operation-manual_1181233014.webp)
Operation
12
Baking in Program Mode
The oven can be pre-programmed with up to 30 Programs; each program can contain a maximum of 3 stages. When you receive your oven,
the controller is not pre-programmed.
1.
SELECTING A PROGRAM.
Press ‘Program’ key.
Upper Display will show program number selected.
+ to scroll forward through programs.
- to scroll backward through programs.
Lower Display will show , oven is ‘Pre-Heating’.
Program cannot be started until pre-heating is completed.
If Lower Display is blank, the vent will be opening or closing to match the
program.
2.
OVEN READY.
Lower Display will show when oven is up to pre-heat temperature and an
alarm will sound.
Load product into oven.
3.
CONNECT CORE TEMP PROBE (IF REQUIRED).
Connect Core Temp Probe to connector on lower right side of control panel,
will be displayed on Lower Display.
NOTE: A Core Temp Probe can be used as part of a multi-stage cooking program.
If a program reaches a Stage that requires a Core Temp Probe and no Core
Temp Probe is connected, an error alarm will sound and ‘CP’ will flash on
Lower Display. The program is automatically paused until the Core Temp
Probe is connected. Once the probe is connected to the control panel and
inserted into the food product, press the ‘Timer-Start / Stop’ key to resume
the program.
4.
START PROGRAM.
Press ‘Timer-Start/Stop’ key to start baking program.
Pressing and holding ‘Timer-Start / Stop’ key for 3 seconds will cancel
the program and return to the Preset Program.
During Program Operation the Upper and Lower Displays will show the following:-
Upper Display shows Program Number, e.g.
Lower Display will show either,
- Total Time Remaining in Program.
OR
- Total Elapsed Time of Program (if any Program Stages are set to CP or InF).
OR
- Alternate between ‘CP’ and Core Probe Set Temp (if presently in a Core Probe Stage).
5.
CANCELLING PROGRAM ‘TIME UP’ ALARM (BAKING TIME COMPLETED).
When program is completed, the alarm will sound.
To cancel alarm, press ‘Timer-Start/Stop’, oven will continue to cook at Oven Set Temperature. Display will revert to
Program Number (Upper Display) and Total Program Time (Lower Display).
Alternatively, open oven door to cancel alarm and turn ‘Off’ fan and heating. Close oven door to resume baking at Oven
Set Temperature. Display will revert to Program Number (Upper Display) and
‘PrH’
or
‘Rdy’
(Lower Display).
‘Program’ LED is
‘On’ when Oven
operating in
Programs Mode.