TurboChef Encore Touch Rapid, Service Manual

Page: 21 / 116

5
CLEA
n
In
G
Daily Maintenance
Follow the steps below when cleaning your oven. Use
only TurboChef®-approved cleaning chemicals. Failure to
adhere to these procedures or the use of any other cleaning
products may damage critical oven components, resulting
in a non-warranty service call.
Supplies and Equipment
TurboChef® Oven Cleaner (Product Number: 103180),
TurboChef ® Oven Guard (Product Number: 103181), Kay
ClickSan® sanitizer, nylon scrub pad, clean damp and dry
towels, disposable gloves, protective eyewear, dust
mask (optional)
Step 1
Tab Location
Step 3
Step 5
Step 4
Step 6
Step 1: Cool the Oven
WARNING: The oven operates at approximately 500°F (260°C) and may cause
injury if not allowed to cool properly.
• Turn off the oven by touching the Off icon.
• Slightly open the oven door.
• Cooling takes approximately 30 minutes.
DO NOT proceed to Step 2 until the oven displays “ready to clean.”
Step 2: Clean the Baking Stone
• Remove the baking stone and GENTLY dry-scrub with a nylon scrub pad to
remove food particles.
WARNING: Scrubbing too vigorously can cause the baking stone to crack and break.
DO NOT immerse the baking stone in water. If it is immersed by accident, allow it time to
thoroughly air-dry before using; otherwise it may crack.
Step 3: Clean the Wire Rack
• The wire rack is held in place by tabs that are positioned underneath either side of the jetplate.
• Lift the rear of the wire rack.
• Pull the wire rack forward until the tabs are free.
• Wash, rinse, sanitize, and dry the wire rack.
Step 4: Clean the Jetplate
• Lift the front of the jetplate.
• Pull the jetplate forward and remove it from the oven.
CAUTION: Handle the jetplate with care to avoid chipping the porcelain coating.
• Wash, rinse, sanitize, and dry the jetplate.
DO NOT clean the jetplate with a wire brush.
Step 5: Clean the Cavity filter (if present)
The filter must remain in place during oven operation, and it must be cleaned regularly or
replaced if damaged.
• Remove the cavity filter from the back cavity wall by lifting the tab and pulling the
filter towards you.
• Rinse the filter with hot water.
• Allow the filter to dry completely.
DO NOT scrub or pull apart the mesh in the filter frame.
Step 6: Clean the Air filter
The filter must remain in place during oven operation, and it must be cleaned
regularly or replaced if damaged.
• Remove the air filter from the back of the oven.
• Rinse the air filter with hot water.
• Allow the air filter to dry completely.
Continued on next page...
!
!
!
Step 2