7
4. Machine commissioning
Support stand
The support stand in the machine front wall is used for storing and transporting the machine, see Figs. 1 and
2. The support stand is raised during sowing, see Fig. 3.
Figure 1. Support stand during storage.
Figure 2. Support stand during vehicle
transport.
Figure 3. Support stand during sowing.
Running gear, adjustable joints and lift cylinders
The adjustable joints of the running gear are locked and immobilized with a locking flat bar whenever the
machine is being loaded or transported. When commissioning the machine, remove the flat bar and re-install
it so that the pins protrude through the elongated slots. The running gear can then be adjusted to
the
unevenness of the terrain, see Fig. 4. The machine should not be used with its back level locked into a rigid
position! Check that the lift cylinder locking taps are open, see Figs. 38–39.
If the machine must for any reason be used with the back level locked in a rigid position, special care must
be taken when driving over uneven terrain. Severe loads will be applied on the back level and individual tires!
Caution!
The machine must not be used without adjustable joint flat bars. These must always be
installed during use.
