Weight stack label and lubrication instructions
1. Wipe front surface of weight stack with rubbing alcohol and wipe dry.
2. Peel off back sheet (adhesive side) from label (#93) and make sure that the label remains
attached to the application tape.
3. Line up hole of the second label to the hole of the fi rst weight plate.
4. Make sure the hole of the last label lines up with the hole of the last weight plate and slowly
press into place.
5. Gently remove application tape and rub each label fi rmly against the weight stack.
6. Once this is complete, repeat this procedure for Top Plate label.
7. Allow labels to stand for 2 days to allow adhesive to cure fully.
8. Open the lube package provided and apply a thin fi lm of lubricant around the fi rst 3 inches of
the guide rods above the Top Plate.
9. After the cables are installed, do a set of reps to spread the lubricant thoroughly.
NOTE:
1. TOP PLATE LABEL GOES ON HOLE OFF CENTER
AS SHOWN BELOW. LABEL WILL COVER HOLE ON CENTER.
Step 10
93
20
CHL-610WS High/Low Pulley w/200 Lbs Weight Stack for CSM-600
www.tuffstuffi tness.com
