Operation
44
Working with accessory equipment
Safety regulations when working with accessory
equipment
•
Only accessory equipment from Tuchel Maschinenbau GmbH
and accessories approved by us may be used. If you have
questions, please contact your specialist dealer.
•
When attaching accessory equipment, the instructions in the
operating manual of the accessory equipment must be
observed.
•
The machine and the accessory equipment must be on a level
and solid ground.
•
The approved axle load limit as well as the permitted gross
vehicle weight may not be exceeded.
•
Observe the machine's centre of mass. The centre of mass
changes when using different accessory equipment.
•
Before attaching accessory equipment, the quick-release
couplings must be depressurised.
•
After the installation check the functioning of the accessory
equipment before placing into operation for the first time
•
Ensure that the accessory equipment is always in a secure
position and that the holding brake is engaged before leaving
the machine.
Installing the accessory equipment
1. Activate the holding brake.
2. Unlock the quick-change unit:
– Pull the locking shaft (1) on the handle outwards.
– Turn the locking shaft so that the locking pin (2) hooks in
behind the locking bar (3).
3. Start the engine.
4. Release the holding brake.
5. Drive the machine close to the accessory equipment.
000039
1
2
3
6. Operate the lift / lower control lever (1) to lower the accessory
equipment to the ground far enough so that it fits underneath
the holder of the accessory equipment.
000040
1
