TT Tooth Transformer TT Transformer, User Manual

Page: 9 / 26

Rev. 5 of 01.08.2020 9
2.3 STANDARD SYSTEM COMPONENTS
Standard set composiTon may vary during promoTonal campaigns.
n° 1 TT TRANSFORMER unit n° 1 external power supply n° 1 TT Mill
3. INSTALLATION
WARNING : the electrical system of the premises where TT TRANSFORMER is installed and used must
meet all applicable standards and regulaTons for electrical safety.
WARNING: DO NOT install in places where there is risk of explosions. DO NOT operate TT
TRANSFORMER in the presence of flammable gases or liquids (anestheTcs, oxygen, etc.).
WARNING : install TT TRANSFORMER in an impact-proof place, which is also free from inadvertent
spurts of water or other liquids.
WARNING : DO NOT install on/above/near sources of heat. Install TT TRANSFORMER in a place where
there is adequate venTlaTon.
WARNING : though portable, TT TRANSFORMER must be handled with care when moved from one
place to another.
WARNING : do not expose to direct sunlight or UV light.
WARNING : plug the power cord into the inlet at the back of the device. Plug the opposite end into a
wall power outlet (fig.5).
WARNING : make sure the voltage and the frequency of the electricity supply match the power raTng
indicated on the external power supply.
Fig.2
Fig.3 Fig.4
Fig.5
Fig.6
Switching on
1. Press the on/off buWon at the back,
switching it to ON (fig.6).
2. TT TRANSFORMER will turn on.
Switching off
1. Press the on/off buWon at the back
switching it to OFF (fig.6).
2. TT TRANSFORMER will turn off.