Tsuruga 471C, Quick Manual, Page: 14 / 52

Installation （ contd. ）
12
471C
Power supply connection
Connect the power supply at terminal No. E1-E3.
Power supply voltage is mentioned on the
terminal nameplate at the time of shipment.
○ AC power supply
AC100 to 240V 50/60Hz
Permissible range AC 90 to 250V
○ DC power supply
DC 24V
Permissible range DC24V ± 10%
!
Caution

Do not use the voltage out of permissible range. It may be the cause of
equipment damage.

Power on / off, power supply should reach up to rated voltage or shut
down within 1 second.

After the power is OFF, pause more than 10 seconds before the power ON
again.

GND (ground) terminal
In case of frequent noise generation on the power source line, it is
effective to earth the ground terminal directly to the ground. If the
instrument is not affected by environmental noise, the grounding can be
omitted. In this case, take care for the ground terminal not to touch
other input terminals, as it is charged with neutral electric potential of
power source voltage.
1
2
3
4
5
6
A B C D E
＋
－
1
2
3
4
5
6
A
B C D E
GND for
power supply
GND for
power supply
AC power supply
DC power supply