TSI Incorporated Q-TRAK Plus 8552, Operation And Service Manual

Page: 14 / 57

Chapter 2 8
4. Select the correct serial port (such as, COM2); then select Test . The
software will verify that you have set up the communications port
correctly and that it is communicating with the Q-T
RAK
Plus
monitor. The system displays an information message indicating
whether it was able to establish communications.
5. As an alternative, select Find Port , to have the monitor search the
available COM ports, looking for an attached Q-T
RAK
Plus
monitor.
6. Select OK to accept the setup, or Cancel to discard the changes.
Using the Optional Instrument Stand
The Q-T
RAK
Plus IAQ Monitor can be used with an instrument stand
(available as an accessory). When placed on a level surface, the instrument
stand is designed to hold the instrument and the probe at a convenient
viewing angle. The instrument stand may also be used to hang the monitor
on a wall.
To use the stand, simply detach the battery door from the monitor and
replace it with the instrument stand (see Figure 2-3).
Using the Optional Probe Stand
A separate probe stand is available as an accessory. Use the bracket that is
located on the probe and slide it on the probe stand as shown in Figure 2-3.
Figure 2-3: Optional Probe and Instrument Stands