TSI Incorporated 8372, Operation And Service Manual

Page: 41 / 55

Operations in More Detail 31
Figure 15: Location of DIP Switches
You may change the switch settings using the tip of a ballpoint pen, pencil,
compass, small screwdriver, or other small, pointed object. Refer to Table 4
for switch settings.
Table 4. DIP Switch Settings
Switch Number Setting: Function
1,2 1 OFF, 2 OFF: Flow units = CFM
1 OFF, 2 ON: Flow units = m3/hr
1 ON, 2 OFF: Flow units = l/s
1 ON, 2 ON: Flow units = m3/min
3 OFF: Pressure units = in. Hg
ON: Pressure units = mm Hg
4
OFF: Temperature units =
°
F
ON: Temperature units =
°
C
5 OFF: Auto shut off = on
ON: Auto shut off = off
6 OFF: Decimal for fractions
ON: Comma for fractions
7 OFF: Field calibration disabled
ON: Field calibration enabled
8 OFF: Audible buzzer on
ON: Audible buzzer off
Connecting the Optional Printer
To connect the Model 8925 printer to the A
CCU
B
ALANCE
Plus, locate the
Printer Interface Cable (supplied with the optional printer) and connect the
9-pin end labeled “PRINTER” to the printer and the other end to the data
port of the A
CCU
B
ALANCE
Plus. The printer can be attached to the base of
the A
CCU
B
ALANCE
Plus by clipping it into the printer bracket located to the
left of the display or by clipping to the belt of the user. The printer must be