Tseng Qtec VGA 1024, Installation Manual

Page: 7 / 123

QUICK INSTALLATION GUIDE
Analog
Operation
If an analog monitor (eg. IBM VGA or NEC MulitSync monitor) is
connected to the Qtec VGA1024 board through 15 analog connector.
Please do the followings:
a. Set all 4 switches of the dip-switch to OFF position (OFF OFF
OFF OFF). This should have been pre-set from the factory.
b. Set Jumper 1 (JP1) to connect the two lower pins and Jumper 2
(JP2) to connect the top 2 pins. This should have been
pre-set from the factory.
c. Switch off your PC and plug the Qtec VGA1024 board into any of
your 8-bit or 16-bit slot.
This is all you need to do to run any VGA software.
Digital Operation
When only the digital monitor is used with the Qtec VGA1024 board
(the 15-pin analog connector is not connected), please consult
dip-switch and jumper settings section of this manual.
Remark:
1. Analog sensing
When your PC power is turned-on, your Qtec VGA1024 board will
sense if its 15-pin analog connector is active (connected).
If yes, the Qtec VGA1024’ board will set itself to VGA mode
regardless of its dip-switch setting.
To run 800x600 and 1024x768, please make sure that all 4
switches of the dip-switch is set to OFF position.
2. Software Mode Switching
For software mode switching, please use DMODE utility program
to switch modes (VGA, EGA, CGA, MDA or Hercules). Please note
that the adapter's current mode will not be re-set by
warm-booting (Ctrl-Alt-Del) the PC. This is a planned
function for users' convenience. To switch modes, please use
DMODE utility or turn-off the PC.
-1-