© TrynEx International 2013 (REV C) F50766
10
Installation Instructions
Installing on the Spreader
STEP 1
Check that Spinner Drive is in “Down” position.
It is recommended that this kit be installed by your SnowEx Dealer.
STEP 2
Remove the Passenger-Side Tank Assembly[F50261 / F50251] from the pallet. The back of the Tank has two raised areas. Push these between
the rails of the Sideframe. The Tank should ‘click’ into place. The tank is in position when centered between the Corner Posts of the Sideframe and
stays ‘clicked’ into the Sideframe. Bolt Mounting Rail in place using the “Tank Mounting Hardware Kit.”
STEP 3
Remove the Driver-Side Tank [F50261] from the pallet. Repeat the procedure of the previous step to install this Tank.
STEP 4
Use parts from the Tank Mounting Kit. Install a Rubber Grommet [D5602] into each of the two holes in the front of the Frame. The holes are on the
side and in line with the ends of the Tanks.
