© TrynEx International 2013 (REV C) F50766
6
Installation Instructions
Connecting to the Spreader’s Control Module
It is recommended that this kit be installed by your SnowEx Dealer.
STEP 5
Remove the Cover of the Power Box.
STEP 1
Unplug the Spreader from all of the plugs on the Bumper.
STEP 2
Remove Spinner Drive Latch Pin.
STEP 3
Put Spinner Drive into ‘Down’ position.
STEP 4
Remove the Auger Extension Cover.
STEP 6
Push out the lower Plug in the rearward-side of the Control Box.
