10
3
.
Installing TRP-C34H Hardware.
STEP1:
Please use screwdriver and then open back of metal, adjust the switch to select
RS232 or RS422/485 function.
STEP2:
Connect the power source from DC-Jack or screw terminal, the PWR LED will
blinking, wait till boots PWR LED ON.
STEP3:
Connect TRP-C34H with Ethernet port by RJ45 cable.
If the cable is properly connected the “LINK” LED will light up.
*The TRP-C34H Support Auto-MDIX, A straight-through or crossover RJ45 cable
can be used to make a connection directly to the HUB/Router/PC LAN port.
STEP4:
Connect TRP-C34H to RS232 device by Null-Modem cable.
Connect TRP-C34H to RS422/485 by AWG #12~30 twisted pair wires.
3-1. RS485 Wiring.
The RS-485 mode supports the Transmit and Receive channels use twisted pair wire half-duplex
operation.
3-2. RS422 Wiring.
The RS-422 mode supports 4 channels with full duplex operation use dual twisted pair wire
half-duplex operation.
.
3-3. RS232 Wiring.
Refer to the Pin out table for connections.
Summary of Contents for TRP-C34H
