Truxta QUADro Q300G, Operator'S Manual & Parts List

Page: 11 / 24

Page 11
Hydrostatic Oil
Top up if oil is below minimum level when machine is cold. If there are any
signs of leakage, stop using the machine and contact your local dealer or
Tufftruk Ltd. Refill with motor oil
— 20W50.
Machine Cleaning
Clean the machine after it has been used to prevent the collection of hardened
debris. Hardened debris is very difficult to remove. To clean it use an old brush
or hand brush with water. Never pressure wash or hose down the engine or
electric motor housing. Clean only with a cloth or compressed air.
Air Filter - If it is dirty, proceed as follows:-
Foam Element - Wash the element in a solution of washing-up liquid and water.
Allow the element to dry, then soak in clean engine oil and squeeze out the
excess oil. If the engine smokes during start-up then too much oil has been left
on the foam.
Paper Element - Tap the element on a hard surface or blow from inside using
compressed air to remove any excess dust within the filter. Replace every 200
hours or if it is extremely dirty.
Transmission Drive Chains
Clean and lubricate the 2 transmission drive chains once a year.
Tyre Pressure
Truxta tyre pressure should be regularly checked and maintained at 25PSI
(flotation and turf tyres)
SERVICE & MAINTENANCE - PETROL
ROUTINE MAINTENANCE
Every
20
hours
Every
50
hours
Every 200 hours
ENGINE OIL CHANGE
CHECK CONDITION
AIR FILTER
CLEAN / REPLACE
SPARK PLUG CHANGE
SPARK PLUG AND OIL DATA
Engine
Oil Type
Qty
(gals)
Fuel Type
Capacity
(gals)
Spark
Plug
Electrode
Gap (mm)
Hydrostatic
Transmission
Oil
PETROL
HONDA
S.A.E
10W30
0.17
UNLEADED
SP95 only -EU
Octane 91 min US
0.53
BPR5
ES
0.07-0.8 20W50