4.6. 6. Heater
The heater is a hot mineral oil heater.
Parts List
1. Oil Heater
2. 10 gallons of Mineral Oil
3. 3/4” inline Check Valve
4. (1) 72” long 3/4” diameter braided stainless steel hose with fittings and valves
5. (1) 48” long 3/4” diameter braided stainless steel hose with fittings and valves
Setup Required by Customer
1. Determine the placement of the heater unit. Note: With the check valve used in the outlet line, the unit
can sit on the floor. Without the check valve, the unit will need to sit on a table about 3-4 feet high.
2. Plumbing setup from heater to the wall. Use 3/4” copper with NO FLUX and NO PIPE DOPE. Place
the Check Valve supplied on the outlet run of the copper plumbing. See images below for a better view
of the plumbing.
3. Run the 3 phase electric required to the heater.
NOTE: The DR-10 unit should close enough to the wall so that the supplied braided stainless hoses
reach the unit from the wall. Please do not try to extend these hoses.
TruSteel
DR-10 CUTSHEET AND OPERATING MANUAL - 1
Page 13 of 21
