TruSteel AV15, Installation Manual

Page: 8 / 43

AV15 INSTALLATION MANUAL | TruSteel AutoVap15 Installation Instructions | v. 1.3
8 / 43
AV15 REQUIREMENT CHECKLIST
For your review below are the pre-installation requirements for the AV15. It is important to
us that we can install your equipment in a timely fashion and to do so, the installation
location needs to be ready. All the items on this list are required to be
completed BEFORE the arrival of TRUSTEEL installation technicians.
Chiller Requirements
☐
The chiller has power and is wired correctly. (Note: you can turn the power on and see
STANDBY displayed)
☐
There is a power disconnect within 10 feet of the chiller.
☐
The chiller has sufficient airflow as per the manufacturerʼs suggestion.
☐
The remote control is wired up and in a mounted in a convenient location.
☐
The expansion tank is properly installed.
☐
The bypass manifold is installed on the chiller.
☐
The plumbing for the chiller is complete to the ball valves/hose barbs, which are on a
unistrut on the wall behind where the AV15 will be.
Water Heater Requirements
☐
There is power to the water heater.
☐
The water heater manifold, provided by TruSteel, is connected to the heater and mounted
securely on the wall.
☐
The manifold is oriented in the correct position (ports are facing out/Taco Pump control
screen is facing out)
☐
The Taco pump arrow is pumping toward the water heater.
☐
The Taco pump is powered by a wall switch
☐
The garden hose coupler is installed
☐
The plumbing run is no more than 30 feet with fewer than 4 total 90° turns.
☐
The plumbing line is run all the way to the ball valves behind where the AutoVap15 will be.
(Note: Run your lines as straight as possible with as few 90s to maximize the flow)
For Gas Heater, Add the following Requirements
☐
Proper supply of gas to water heater
☐
Flow Meter Switch is installed
☐
Aquastat is properly installed on water line