9
Troubleshooting
Air flows continuously
through the plastering
machine.
The material is not
spayed correctly.
The material is
scattered when hitting
the wall or ceiling.
The material is not
being shoot out
through the nozzle.
• The texture gun internal valve is activated
with the trigger and may be stuck or dirty
.
• The compressor is too small.
• The mix is too thick or is dry.
• The pressure is too high.
• The material was not prepared right.
• Disassemble the texture gun to clean and
check there are no damaged O-rings. If so,
replace.
• The compressor shall be able to work with
pressure between 40 PSI and 90 PSI.
• Thin the mix with water.
• Verify adjustments. See the textures table. If
using a tank compressor, regulate the air.
• Check the mix preparation procedure.
Problem
Cause
Solution
TRUPER, S.A. de C.V.
Parque Industrial No.1, Jilotepec, C.P. 54240, Estado de México, México
TEL. 01(761) 782 91 00, (TIN) R.F.C.: THE-791105-HP2
www.truper.com
03-2019
ENGLISH
Summary of Contents for 19233
Page 10: ...Notes 10 ENGLISH...
Page 11: ...Notas 10 ESPA OL...
