Maintenance
10
• Remember to always disconnect the tool before
cleaning or making any maintenance job.
• After using the cutter please check for any abnormal
issues. In case of unusual noise, strong flaming, low
speed or any strange occurrence, before you use the tool
again please go to a Authorized
Service Center to fix the problem.
• Verify regularly if parts such as the guard or the handle
is broken; or the power cable, switch or trigger is in good
working condition. Also see if any accessory might be
damaged.
• All the tool components are an important part of the
insulating system. They should only be taken care in a
Authorized Service Center.
• When you sent the tool out for maintenance please ask
for original spare parts.
• After having checked out and confirm the cutter is in
excellent working conditions, please clean it and store it
adequately.
• If the cutter will not be used for long periods of time
please store it in a dry, safe place. After a long period of
storing verify the electric insulating of the housing and the
trigger.
• The cutter runs at high speeds. The lubricant may
vaporize with the passing of time. Adding grease every six
months of use is recommended in its cogwheel system.
This is only performed in a Authori-
zed Service Center.
• Stop using the cutter if the power cable, insulating or
guard are damaged; if the plug or switch do not make
contact and if the tool stops working all the time, and if
strong flaming appears. Do not use the tool if any of the
abovementioned problems appear.
• Use compressed air or a brush to clean after each use,
with special CAUTION to the ventilation system. Do not
wash directly the bottom of the motor. When cleaning
plastic parts avoid using solvents; most of plastic materials
are susceptible to get damaged with different types of
commercial solvents.
• Replace the carbons when they are less than
3
/
16
” ,
when the longest side of the carbon is shorter than the
wider side or, when the springs or cables are burnt or
damaged.
• Unplug the machine to check or replace the carbons.
Remove the carbon cap in the motor housing. Do this
carefully so that the carbon will not jump out when the
spring pushes. Pull the carbon out and repeat the
operation in the other side.
• If the carbons are in good condition, install them back in
the same position they had when checked. Otherwise,
replace with new carbons.
• When replacing carbons please change both at the
same time.
• Use only original replacement
carbons, designed specifically with the hardness and
electric resistance adequate for each type of motor.
Carbons out of specification may damage the motor.
Carbons replacement
• Servicing the tool should always be made by a
Authorized Service Center.
• Service and maintenance jobs made by non-qualified
people may be dangerous and could cause personal
injury. It also makes the Warranty void.
• When sending the tool for servicing, please ask to use
only original spare parts. Using unauthorized parts, or
failing to follow maintenance instructions may be a risk of
electrocution or injury.
Service
ENGLISH
