E614EN_03.DOC
Operation
13
1 On/Off
switch
¾
Push the on/off switch forward until it locks into place.
1. Do not move the machine towards the workpiece until full
speed has been reached.
2. Machine
the
material.
–
Machine the desired cutting line
3. In the event that the cutting track ends in the sheet, pull the
still-running machine a few millimeters back towards where the
cutting track has already been cut open.
4. Switch off machine.
¾
Push the rear part of the on/off switch.
Note
The cutting result is improved and the service life of the punch
increased if the cutting track is coated with oil before machining the
workpiece.
Material
Oil
Steel
Punching and nibbling oil ( 0.5 l, order no. 103387)
Aluminum
Wisura oil (1 l, order no. 125874)
Switching on and off
Fig. 52403
Switching on the
TruTool N 500
Working with the
TruTool N 500
Switching off the
TruTool N 500
Table 6
