Note
To grease, use lubricating grease "S1" (order num-
ber 121486).
5. Apply a thin film of grease on the square part of the punch
and die holder bore.
6. Screw in the punch and align to 45°.
7. Check the penetration depth of the punch with the setting
gauge (order number 1411767).
8. Close the locking mechanism.
Changing the die and punch guide
1. Unscrew and remove the screws (4).
2. Clean the support areas on the die carrier (7).
3. Clean the replacement parts if necessary.
Note
To grease, use lubricating grease "S1" (order num-
ber 121486).
4. Lubricate the guide surfaces of the punch guide.
Note
Use original screws only.
5. Tighten the screws (4) (torque 40 Nm).
5.2
Regrinding the punch
Notes
■
Dies cannot be reground.
■
Use only original spare parts from TRUMPF.
■
The punch can be reground in total 5 to 10 mm, depending
on with which die it is used. Shorter punches must be
replaced (risk of collision).
Type of die
Minimum length X
Regrinding reserve
for punch
P10
92 mm
5 mm
10
89.5 mm
7.5 mm
7
87 mm
10 mm
E232en_06
Replacing the tool
19
