User Manual
4
FEATURES:
Our XB-series automatic flake ice makers are designed in cubic shape with the
curved front panel and curved door (or stainless steel flat front panel and flat
door) for nice appearance. Many advantages of the ice maker are available, such
as ice making quickly, great ice making capacity, nice ice shape and ice dropping
quickly. Tap water inlet→water incoming→ ice making→ crush ice → ice
dropping→ ice storing, all these processes are automatically controlled for ice
making continuously. In case of water shortage or ice full in cabinet, the indicator
on the operation board will light on accordingly and the ice maker will stop
operation automatically. The ice storage cabinet is PU foamed, so it is insulated
well and it could prevent the ice made from melting. Also, the remaining water
after ice made each time is used recycling. So not only the water is saved, but
also the ice making efficiency is enhanced and the energy consumption is
reduced, and the customer's ice making cost is also reduced much. Either
purified water or the tap water could be used for ice making.
NOTES BEFORE OPERATION:
1.
The incline angle of the cabinet could not be over 45° during
transportation. Don't make ice maker upside-down in case the compressor
or refrigerating system troubles occur.
2.
The flake ice maker should be placed on horizontal and structurally sound
ground and away from heat source and corrosive gas. At least about
150mm room should be left around the ice maker to ensure the fine
ventilation.
3.
Before using the flake ice maker for the first time, you should wait 12 hours
after positioning it in a proper place.
4.
Voltage range:187
～
242V(220V)
5.
The rated capacity of wire should be over 6A, the section area of the wire
is 0.75mm .The wire could be consisted by single ply or multiplies. The
rated current of fuse is 5A.
6.
The separate three-pole outlet should be used and the grounding must be
good.
7.
If the supply cord is damaged, it must be replaced by the manufacture, its
service agent or similarly qualified persons in order to avoid a hazard.
8.
This appliance is not intended for use by children or other persons without
assistance or supervision if their physical, sensory or mental capabilities
prevent them from using it safely. Children should be supervised to ensure
that they do not play with the appliance.
