FRONT VIEW
CHARGING
This product is partially charged from the manufacturer. Fully charge the unit immediately after purchase. In order to prolong the
internal battery life, be sure to fully recharge the unit after each jumpstarting, or every month even if this unit has not been used.
In addition, we recommend not to charge and discharge the unit at the same time.
To check the internal battery’s charge status, press the Battery Voltage and % Indicator button (the screen will turn off in 10
seconds). Charge the internal battery if the display shows it is under 100%.
NOTE:
The internal battery’s percent of charge is most accurate when the jump starter has been disconnected from all devices
and charging sources for a few hours.
AC Charging (Recommended):
1. Insert AC charging adapter into charging jack of the unit.
2. Plug the other end of AC charging adapter into a wall socket.
DC Charging in Your Vehicle:
You may also charge the internal battery while driving, using a male-to-male (insertion plug at each end) charger cable.
1. Turn the vehicle engine on.
2. Insert one end of the accessory cable into the 12V DC power outlet.
3.
Insert the other end of the accessory cable into the vehicle’s accessory outlet (lighter socket).
4. Turn on the Jump Start + 12V DC Power On/Off Switch.
NOTES:
Using DC charging method to charge the battery overrides the maintain mode and the battery can be overcharged.
Monitor the progress of the charge by pressing the Battery Voltage and % Indicator button and do disconnect immediately after
battery is fully charged. Completely disconnect the charger cable when the engine is not running.
JUMP STARTING
1.
This unit is only for emergency use, not for frequent commercial use! Do NOT attempt to jumpstart your vehicle when the
unit’s battery capacity is below 30%.
