Trueshopping
www.TrueShopping.co.uk
Page:
of 26
15
Using The Welder
1. Fitting the welding rod
Select the appropriate welding rod, and insert it into
the welding rod holder. It should be approximately the
same thickness as the workpieces being welded.
2.Preparing the workpiece
The area being welded should be perfectly clean. Any
coating, plating or corrosion must be removed,
otherwise a good weld will be impossible to achieve.
3.Thermal cutout
If the machine stops at any time and the amber light on
the front panel illuminates, the thermal cutout has
activated. Wait until the transformer has cooled
sufficiently(the amber light goes out) before restarting
work.
4. Attaching the earth clamp
Attach the earth clamp firmly to the workpiece as close
as possible to the point of weld.
IMPORTANT: Ensure that the earth clamp is attached to
clean, solid metal. If necessary, thoroughly clean with a
wire brush or similar to guarantee a good connection.
5. Switching ON
Select the welding current by turning switch on the
front panel. Switch ON the machine
6. Striking an arc
IMPORTANT: BEFORE you strike an arc, always bring
the face shield up to protect your eyes.
a. Line up the electrode exactly over the spot where
you want to strike.
