Trueshopping 62cc, Assembly & Owners Manual, Page: 14 / 170

! Be careful when shutting down the machine
as it will continue to run for several seconds
before coming to a stop.
! Beware of falling branches and branches
that may spring back on you
.
! You must use the provided extension pole,
do not lean or stretch as this may cause you to
fall
.
! Do not use the pruning saw when standing
on a ladder or uneven surface, you may lose
balance and cause severe injury to yourself or
others
.
! The machine produces exhaust fumes
including Carbon Monoxide, do not use the
unit indoors or in non-ventilated areas
.
! This machine should not be operated by
anyone under the age of 18
.
! This machine should not be operated b y
persons of limited capacity .
! Do not operate the machine if under the
influence of alcohol, prescription medicine or
any substances which may impair your
judgement
! Be wary of your environment, do not
operate the machine in adverse weather
conditions. Clear any obstacles from the
working area
.
Storage instructions
If the unit is to be stored for long periods of
time please read the following –
•
Drain the oil and fuel tank, fuel vapours
can build up and pose a fire hazard
•
Remove and clean the blade
•
Wipe the machine down with a cloth
soaked in mild soap solution and dry fully
•
Store in a dry place
•
Keep in a locked area and keep out of the
reach of children
•
Allow the engine to cool before storing
• Ensure all fixings are tight on the unit
Inspection and maintenance
Regularly check:
•
The air filter
• The spark plug
•
The chain bar and blade
Guide Rail Maintenance
Turn the guide rail every time the chain is
replaced or sharpened. This will prevent one
sided wear of the rail, particularly on the top
and bottom. Clean regularly
.
Fuel pipe / Tank grommet exchange
! Please ensure the unit is completely drained
of fuel before attempting this procedure.
•
Unscrew the retaining cap and remove
the air filter cover.
**The retaining
cap will be a Philips screw on certain
models**
•
Remove the fuel pipes from the
carburettor using long nosed pliers and
a small flat headed screwdriver, noting
the location of each pipe before
removal.
Black pipe = Feed/Supply
Clear Pipe = Return
12