CHAPTER 2: ASSEMBLY INSTRUCTIONS
TREADMILL ASSEMBLY STEPS:
STEP 1: Remove Motor Cover:
a
) Remove two screws (l) and two
Motor Decoration Covers from
Frame.
b
) Remove seven screws (m) and
Motor Cover from Frame.
c
) Set hardware to the side for use in
step 4.
STEP 2: Pedestal Installation:
a
) Check that Hex Head Bolts are
backed out enough to clear the
Pedestals when installed.
b
) Install Pedestal – R (D) into
pedestal support on Frame (B) while
pulling four cables out of pedestal
support as shown in Fig. 2-1.
NOTE
: Be careful not to pinch cables.
c
) Install Pedestal – L (C) into
pedestal support on Frame.
d
) Using 5mm Hex Key, install but do
not tighten eight Bolts-M8 x 75mm
(b) and Washers-M8 (d) as shown .
Required Hardware:
8 M8 x 75mm Bolts (b)
8 Internal Tooth M8 Washers (d)
Truefitness.com / 800.426.6570 / 636.272.7100
11
Summary of Contents for TC400
Page 10: ...CHAPTER 1 SAFETY INSTRUCTIONS Truefitness com 800 426 6570 636 272 7100 6 ...
Page 39: ...CHAPTER 6 ADDITIONAL INFORMATION WIRING DIAGRAMS Truefitness com 800 426 6570 636 272 7100 35 ...
Page 40: ...CHAPTER 6 ADDITIONAL INFORMATION WIRING DIAGRAMS Truefitness com 800 426 6570 636 272 7100 36 ...
