WINE AND BEVERAGE CABINET USE AND CARE MANUAL
24
Figure 8
Figure 9
Figure 7
Step 7
hook up the pressure regulator to the Co
2
tank. using a
adjustable wrench make sure the nut is tight.
(See figure 7)
Step 5
remove the cap and run the air hose to the top of
the draft standard. hook the hose onto the stainless
tube to keep hose from falling out (this hose will keep
the draft standard cold).
(See figures 5 & 6)
.
Figure 5
Figure 6
Step 6
reinstall the cap.
Beer hose Connection
Step 8
Place Co
2
tank in the unit using the black strap provided.
to secure the tank use one of the screws from the
evaporator cover. the tank can go in either the left or right
side back corner. Run 3/8” hose from the regulator to the
tapper and secure with clamps. hook the beer hose to
the tapper making sure the rubber washer is between the
flanges.
(See figure 9)
Step 9
Install the beer tapper onto the keg. the tapper has
notches that must line up. once the notches are lined
up, turn the tapper to secure it to the keg. once secured,
pull outward on the handle. While pulling, press the tap
lever down to engage. release the handle and the tapper
should stay engaged to the keg.
(See figures 8 & 9)