CHAPTER 2: ASSEMBLY INSTRUCTIONS
Truefitness.com / 800.426.6570 / 636.272.7100
18
LATERAL TRAINER ASSEMBLY STEPS (continued):
STEP 1
1
: INSTALL TRANSCEND CONSOLE (continued):
STEP 1
2
: INSTALL THE CONSOLE AND HANDLEBAR PLASTICS:
a)
Slide the Front Handlebar Plastic
(
J
) into position below the Handlebar
Grips Assembly. Install the 1 screw to
hold the Front Handlebar Plastic in
place.
b)
Slide the Rear Console Cover (
K
)
into place behind the console.
NOTE:
Use caution so you do not
pinch any wires
c
) Use 5 screws to tighten the Rear
Console Cover to the back of the
console
STEP 1
3
: MOVE MACHINE TO FINAL LOCATION AND SET LEVELING FEET:
a)
Tilt the machine forward by
holding onto the Hand Grips in the
locations shown to the right and
move the machine on the Transport
Wheels.
b)
Once the machine is in the final
desination, adjust the leveling feet
until the unit is stable.
J
K
Grab the unit in these
spots to move the
machine.
DO NOT
PULL ON CONSOLE
.
Zip tie cable to
this bolt
h
) Route the AUXPS DC power cable
as shown and secure with a zip tie.
i
) Re-assemble the plastic cover to the
front of the machine using the 8
screws that were removed.
