Page 3 of 37
3. True-i gateway connection type
3.1 Access Point (AP) mode connection (For changing of user’s wifi setting)
1)
“RESET” button for switching to AP mode
connection.
2)
Micro SD card slot for keeping video
recording and firmware upgrading.
3)
“STATUS” LED and “POWER” LED for the
True-i gateway.
When pressing “RESET” button, it is
recommended to use a paperclip or sim
card extractor.
To access the gateway via AP mode, please do the
following steps.
4)
Press the “RESET” button according to the
direction as shown in the figure with red
arrow line. Please take note that the user has
to feel the “PUSH” button on the device.
Please take note that the user has to press
and hold the “RESET” button for about 10
seconds until the user hear two beeping
sounds. In any case of user cannot hear the
two beeping sound, please power ‘OFF’
and ‘ON’ the gateway and wait for about 5-
10 minutes to reconnect the gateway.
5)
The status light of the gateway can be seen as
shown in the picture if the gateway is in AP
mode.
Status LED: Solid ORANGE
Power LED: Solid RED
More details on the LED light code can be
found in section
3.3 LED light code
.
