5 5 0 Z T X T r e a d m i l l O w n e r ’ s G u i d e
Error Codes
C
ARE AND
M
AINTENANCE
66
E1:INCLINE
Incline moving when not commanded to.
E1:RANGE
Difference between zero position and
maximum incline not sufficient.
E1:STALL
Incline not moving when commanded to.
E2:OVERSPEED
This error occurs when an acceleration of
greater than 2.1 mph occurs. Error cleared
by turning off power switch then turning
it back on.
E2:CAL
Treadmill cannot achieve target speed.
Re-calibrate treadmill.
E3:RECAL
This error occurs when a data error is
detected in the EEPROM. Replace the
control panel.
E4:KEY STK [stop]
Caused by pressing and holding the
key for more than five seconds.
E5:SENSOR
This message is displayed when there is
no speed feedback.
All errors require service by a qualified technician. To clear
the error, turn power off and back on again.
C
ARE
AND
M
AINTENANCE
E
RROR
C
ODES
Summary of Contents for 550ZTX
