36
7
» Y081564 - (EN - REV. 003) | JUNE 2022
TAPPET AND BOOT ASSEMBLIES (13) AND INNER SEALS (22) REPLACEMENT
7.3.1 - Press-in tool (
E
1
)
7.3 - Tappets supplied with long-life lubricant and protective cap
7.3.3 - Fit new tappet bush / tappet with boot assembly to the spigot
7.3.4 - Press in the tappet using tool (
E
1
)
7.3 Fitting of Tappet and Boot Assemblies (13)
With caliper installed on the vehicle:
7.3.1. To fit the tappet and boot assemblies (13), use tool
(
E
1
) (see Fig.).
7.3.2. Wind back fully the threaded tube (16) until it stops
and then wind forward one full turn (see Section 6.1.4).
7.3.3. Fit new tappet bushes (161) onto the spigots of the
threaded tubes (16), then follow with the tappet and boot
assemblies (13) pushing them into position (see Fig.).
Note:
The sealing surface (
X
) on the boot and in the caliper
must be clean and free of lubrication.
7.3.4. Position tool (
E
1
) so that (T28) and outer rim of (T55)
touches the brake disc. Using a spanner, screw out (T03) to
press tappet and boot assembly (13) into place (see Fig.).
The Tappets are supplied with a special long-life lubri-
cant within a protective cap.
Before fitting, the protective cap must be removed and
discarded in the appropriate manner. The lubricant must
not be smudged or removed. Transfer of the lubricant to
other parts should be avoided. Also adding additional
lubrication from any other substance is not allowed.
XX
13
T03
‘E
1
’
13
161
161
(E
1
)
T55
T28
T02
T03
T55
