45
9
(D
1
)
(D)
(D
2
)
» Pneumatic Disc Brake SL7 - SM7
9.1.1 - 9.1.3 - Remove parts as described
9.1.4 - Remove inner boot
9.1.5 - Check for damage or corrosion
9.2 - Tool combination (
D
)
To replace the caliper bearings, all components of the fixed
and floating bearing must be replaced by new components.
For ease of reference, each component of a tool is referred to
by an identification number (see section 2.1).
9.1 Removal of Inner Boot (9)
9.1.1 Remove caliper (see Fig. and Section 8.1).
9.1.2 Remove ring (58) (see Fig.).
9.1.3 Pull out guide pins (4 and 5) (see Fig.).
9.1.4 Ease out inner boot (9) with a screwdriver or similar
tool (see Fig.).
9.1.5 Check the sealing face of inner boot (9) for damage or
corrosion (see Fig. arrow
A
).
9.2 Replacement of Brass Bush (7) Fixed Bear-
ing Side
For ease of reference, each component of a tool is referred to
by an identification number (see section 2.1).
To remove the brass bush (7) use the pull-out combination
(
D
1
).
Before mounting the tool, lightly lubricate the washer DIN
125 both sides with white grease.
To fit and groove the brass bush (7) use the pull-out/pull-in
and grooving tool (
D
2
).
Washer
DIN 125
Tool combination to pull in
brass bush (7)
Tool combination to push out the
brass bush (7)
9.
CALIPER BEARINGS REPLACEMENT
*
Variants
A
T12
T16
T14
T13 T08
T14
T13
5*
40*
6a*
6b*
4a*
4b*
9*
58a
6f
7*
10*
39a*
68a*
68f
58f
39b*
39f
