Tru-Turf R52-ELTac, Manual

Page: 41 / 58

TRU-TURF R52-ELT
AC
Golf Greens Roller Manual 38
Smoothing Roller Bearings & Seals - Replacing
ROLLER ASSEMBLY INSTRUCTIONS
1. Clean any dirt or swarf from the ends of the shaft and remove any rust that may be on the end of the shaft with a fi ne
emery paper.
2. Lightly press one of the supplied new bearings into the one end cap of the roller.
3. Slide the shaft into the roller and thru the bearing.
Install a circlip against the bearing ensuring it is correctly seated in the circlip groove in the end cap.
4. Repeat steps 1 & 2 for the other end.
5. Apply a liberal amount of standard axle or bearing grease to the exposed shaft and the hollow between the lips of the
new seals.
6. Fit the supplied new seals (2 per roller supplied) into each end cap, note the seals must face inwards.
Lightly press each seal in making sure it is sitting square, then using a suitable tool press the seals in until seated against
the shoulder in the roller tube end cap.
7. Before reinstalling the roller into the smoothing head, check that the roller turns smoothly on the shaft but with a slight
resistance.
NOTE - TWO (2) ADDITIONAL CIRCLIPS ARE INCLUDED IN THE KIT IN CASE OF DAMAGE.
There is an alternative seal available that replaces the V seal, see below for details.
5(029(287(5&,5&/,3(1'6+,(/'$1'96($/)520%27+(1'6
(1685(7+(6+$)7,6&/($1$1')5(()520'(%5((
$33/<*5($6($1'),71(:56($/6
287(5&,5&/,36(1'6+,(/'696($/6 ,16(576
$5(',6&$5'('$67+(1(:6($/63529,'(&203/(7(
3527(&7,21)5207+(,1*5(662))25,*10$7(5,$/
$33/</,%(5$/*5($6(72
6+$)7$1'/,362)6($/
72(1685(/8%5,&$7,21
:+(1),77,1*7+(1(:6($/7$.(&$5(12772'$0$*(
7+(/,36:+(16/,',1*21726+$)7$1'3$677+(*5229(
(1685(7+(6($/,6),77('+$5'$*$,167
7+(6+28/'(52)7+((1'&$3
1(:6($/
5
$33/<*5($6(727+(
9$//(<%(7:((1
$//$5281'7+(
/,362)7+(1(:6($/
5(029(7+(6(3$576
)520%27+(1'6
THESE 4 ITEMS
ARE NOT USED