Tru-Turf R52-ELTac, Manual

Page: 10 / 58

TRU-TURF R52-ELT
AC
Golf Greens Roller Manual 7
Assembly
Step 6: Lubricate smoothing head pivot bearings.
• There is a grease nipple or zirk located on the upper
main bearing that supports and carries the ‘T’ frame
and three (3) smoothing head centre ball joint swivels.
Apply grease to lubricate fi ttings.
• Apply grease to the upper main bearing that supports
and carries the ‘T’ frame and three smoothing heads.
Step 7: Apply the Park Brake.
• The park brake lever operates on an over centre
principal.
• To engage the park brake, pull the park brake lever
fully up and back.
• The park brake lever will remain in this ON position.
• To disengage the park brake, push the park brake lever
fully forward and down.
• The park brake lever will remain in this OFF position.
• Always operate the roller with the park brake OFF.
Caution: Do not operate the roller with the park brake
engaged as this will damage park brake components.
When stopping and before getting off the
machine always apply the Park Brake.
Testing Park Brake
1.
Stop the machine safely on level fl at ground & engage
the park brake.
2.
Switch off & dismount from the machine.
3.
Try to push the machine manually.
Result: Park brake must prevent machine from moving. If
machine moves, parking brake needs to be adjusted.
Adjust park brake by rotating the knob on the end of the
lever in a clockwise direction when looking directly at the
end of the lever.
Raising / Lowering Transmission Cover
WARNING! The key switch must be turned off before
performing the following procedure.
To raise the transmission cover.
• Insert the key supplied with the machine into the latch
at the front of the transmission cover.
• Rotate the key counterclockwise (to the left) until it stops, there
will be some initial resistance encountered, this is normal.
• Lift the front of the transmission cover up and carefully tip it
backwards until the gas struts reach the travel limit.
To lower the transmission cover.
• Pull the cover towards the front and carefully lower the
transmission cover onto the rubber corner rests mounted on
the body.
Insert the key supplied with the machine into the latch at the
front of the transmission cover.
• Rotate the key clockwise (to the right) until it stops, there will
be some resistance encountered in the last stage of rotating the
key, this is normal.
It is essential that eff ort is applied to overcome the latch
resistance as this is the point at which the latch mechanism
pulls the transmission cover down slightly onto the body. This
ensures the transmission cover can not become loose.
Adjusting position of Speed Foot Pedal.
•
Loosen the 2 bolts located at the rear outer corners of the foot
pedal assembly, do not fully remove the bolts.
•
Slide the foot pedal assembly towards the front or rear until
you fi nd the most comfortable position to suit your leg and
foot.
•
Tighten the 2 bolts.