rollers
GR7000C GOLF GREENS ROLLER - Operation, Maintenance & Parts Manual
CORRECT DAMPENER STRUT OPERATION
•
When the roller is in the trailing position and the front of the roller resting on the ground, carefully
hold the drawbar assembly, release the locking catch. With a firm grip begin to raise the drawbar,
when it has travelled sufficiently the dampener strut will take over & prevent the trailer arms rapidly
rotating on it’s axle, allowing the roller to lower to the surface. This prevents the operator from being
injured. When the roller is resting on the ground push the trailer backwards gently, (do not use
excessive force) until the trailer arms will travel no further. The dampener strut is designed to hold
the trailer back behind the operator and the wheels off the ground.
REPLACE ENGINE OIL
•
A tag is placed on the engine’s On/Off switch indicating you must fill the machine with oil prior to
operation. Low oil level will cause engine to stop on steep hills, the engine cut off safety switch is
designed this way to protect the engine from damage if low in oil.
•
The oil in the engine upon delivery (if not pre-delivered) is to prevent the inside of the engine from
corroding, replace it with the correct engine oil, as per the manufacturers specifications.
REPLACE TRANSMISSION OIL
•
Ensure oil in transmission is hot prior to draining the oil.
•
Remove drain plug from bottom of transmission using a socket and extension.
•
Protect rubber coated drive roller from the draining oil. Oil left in contact with the rubber could
damage it’s surface.
•
When oil has fully drained, replace plug and fill with recommended oil only - Refer to maintenance
schedule on pg. 13
•
Fill through the upper plug on top of the transmission ensuring no contaminants enter the
transmission. (If this occurs rapid deterioration will occur and warranty will not apply).
•
When transmission is full, leave the plug out and fill the plastic expansion cup with 3/8” of the
same oil. Allow the oil to gravity feed into the transmission until the oil overflows from the plug hole,
expelling trapped air. Replace cap and tighten.
OPERATION AND MAINTENANCE
